| |
|
|
Mobile Drill Intl
US Office
3807 Madison Avenue
Indianapolis, IN 46227
1-800-766-3745
Sales@MobileDrill.net
|
|
| |
 |
Rigs
Available Now
To discuss any of the listed
rigs, please contact Tim Sabo, President at 1-800-766-3745 or Tim.Sabo@MobileDrill.net.
B59 Pre-Owned
|
Available for Rent or Purchase
Click here for Full Specs
|
Specs
CARRIER
1995 Ford F-800, 6cyl Diesel engine, 80,888 miles
33,000 lbs GVWR, 2 - 50 gallon fuel tanks, Air Brakes
7,231 hours on drill
Paint - Mobile Standard Red
BASIC UNIT SPECS
3F/1R speed Transmission /Torque Converter
2 speed Right Angle Drive with 3 speed clark transmission
allows F/R 6 speed rotary spindle.
High Torque Rotary Box - 2" kelly bar drive/4-3/4" open bore spindle
2 Hydraulic Feed Systems - 28,500lb. retract force/ 20,000 lb.
feed force.
30' Mast
Proportional/Electric over Hydraulic Controls
Mobile LIFELINE Shutdown Switch w/ manual reset
Mast Raise/Lower Safety Alarm
100 HP Cummins 4BT 3.9 Turbo charged diesel Engine -
260 ft/lbs torque
BASIC UNIT OPTIONS
120 psi Utility Air Compressor
In/Out Slidebase - up to 15" movement
Sideways Slidebase - 12" of side travel/ 6" off center
Hydraulic Break-Out Wrench
2" Mast Standpipe
HOIST & SPT SAMPLING OPTIONS
8,500 lb.Main Hoist - Bi-directional hydraulic planetary hoist
with fail-safe hydraulic brake
4,500 lb Auxiliary Hoist - Bi-directional w/ fail-safe hydraulic
brake.
SAFE-T-DRIVER Hoist - 900 lb capacity
2,500 LB Cathead
ROTARY HEAD SPINDLE ATTACHMENTS
Mobile Gimbal Coupling
Auger Quick Change for the Hydraulic Chuck, Fluted Kelly and
Manual Chuck.
BODY FABRICATION AND MOUNTING OPTIONS
Body Fabrication - A custom fabricated steel body 14'lg
Underbody Drill Rod Storage Rack 10'-6 D x 23 1/2" W x
2-3/4"H
Hinged Auger Racks mounted under deck both sides of drill
2 Double Tool Box - 6.2 cubic ft tool box (16" H x 42" W x 16" D)
Rear Under-Deck Tool Box
Front Frame Extension
Tilt Front Jack Option
1 - 36" Front Mounted Leveling Jack w/ 12" swiveling pad
2 - 36" Front Mounted Leveling Jacks w/ 12" swiveling pad
250 gal. Water Tank/Combination 10" x 24" x 94" Tool Storage
Steel Operator / Helper Step Platform
Safety Hammer Rack
OTHER OPTIONS
Main Hoist Free Spoiling Option
TRAINING AVAILABLE AT MOBILE DRILL
|
B57 Pre-Owned 90 Day Warranty
|
Available for Rent or Purchase |
Specs
Mounted on 1990 F 800 4x2
Ford Diesel, 30,000 GVWR
5 speed transmission
with
2 speed rear axle.
8500 Ft Lbs Torque
2 Speed Right Angle Drive, 8 Forward Speeds 2 Reverse Speeds
5 Speed Manual Transmission
13” Clutch, Speed Range 65 – 800 RPM
Pulldown 18,650 lbs
Retract 28,270 lbs
3.250” Hollow Spindle
Cummins 4BT Diesel Powered
26’ Heavy Duty Mast with 4 line Crown Block
8500lb Pullmaster Main Hoist
Safety Driver Hoist
3200lb Koenig Auxiliary Hoist
4 Jaw Manual Chuck with NW Jaws
Quick Change Adapter with 2” Auger Coupling
In / Out Slidebase
Side to Side Slidebase
12’ Body Fabrication
2 Manually Hinged Underbody Auger Racks
Underbody Rod Storage
Tilt Cab Option for Front Jack
Front Frame Extension
1 Front Mounted 36” Leveling Jack
2 Rear mounted 36” Hydraulic Leveling Jacks
250 Gallon Water Tank with Lock up rod storage under tank
1 1/4” Mast Standpipe
Lockable Battery Box
Driller Platform
140lb Safety Hammer Rack.
3L6 Progressive Cavity Water Pump
Redi Rack
|
B53 In Stock
|
Available for Rent or Purchase |
For details, give us a call at 1-800-766-3745 or send us an email.
|
|
ROC-L7 CR Used
|
| |
Click image to enlarge.
|
Atlas Copco ROC-L7 CR rock drill, with
a Cat C 11 diesel engine and a Drifter COP 4050 ME [40 Kw] top head. Spares
included are Anvil, PLC, Flush Head, Accumulator, 3 Sensor Leads, Set of Drifter Hose and reel slides, feed chain bearing, Drifter gear box bearing, a quantity of 10 127mm button bits, and a quantity of 5 6m x 102mm Copcorods.
For more information on this used rig, please contact Tim Sabo, President at
1-800-766-3745 or Tim.Sabo@MobileDrill.net.
|
| V2200 New |
 |
Specs
To view full general specifications for
the V2200 click here. |
| V2000 New |
 |
Specs
To view full general specifications for
the V2000 click here. |
| Minuteman New |
 |
Specs
To view full general specifications for
the Minuteman click
here. |
|
|
Specs
CARRIER
1989 Ford, F350, 4 x 4, 34,310 mi. - Condition good
SPECIFICATIONS
Hydraulic Systems
Rotary Drive System - Spindle has five speeds forward and reverse
and has an open bore of 2-3/4"
Maximum spindle torque
in low gear is 4,450 ft/lb. @ 60 rpm and the maximum rotation
speed is 460 rpm in fifth gear
Upright Feed System - 17,600 lb. of retract force @ 65 fpm and
13,250 lb. of feed pressure @ 80 fpm. 6 ft of feed travel
Operators Control Panel - Left rear
Mobile's LIFELINE emergency shutdown system w/ manual
reset
BASE UNIT
Ford 172 cu in gasoline engine
1-1/8" Hex Safety Drive Coupling
BODY FABRICATION AND MOUNTING OPTIONS
Body Fabrication - Custom fabricated steel body provided
to mount the drill unit and optional equipment
4" x 5.4 lb/ft
structural steel channels are the main sills of the body
Decking
is 12 gauge safety plate.
Wood sills are used the full length
between the vehicle chassis members and the structural steel
channels for mounting. 8 ft long
2 Combination Auger / Rod Rack - A 5' auger rack, deck
mounted both sides
2 Lockable Single Tool Box - 3 cubic ft tool box (16" H x 16" W x
21" D) both sides
TRAINING AVAILABLE AT MOBILE DRILL
|
B57 SOLD Pre-Owned 90 Day Warranty
|
|
|
Specs
Mounted on a 1989 Ford diesel F700 4x2, 30,000 GVWR with a 5 speed transmission and 2 speed rear axle.
8,500 ft-lb Torque
2 Speed Right Angle Drive, 8 forward speeds, 2 reverse speeds
5 Speed Manual Transmission, 13" Clutch
Speed Range 65-800 RPM
Pulldown: 18,650 lbs
Retract: 28,270 lbs
3.25" Hollow Spindle
Cummins 4BT Diesel powered
30' Heavy Duty Mast w/ 4 Line Crown Block
8,500 lb Pullmaster Main Hoist
3,200 lb Koenig Auxiliary Hoist
1,200 lb Wireline Hoist
In/Out and Side-to-Side Slidebase
12' Body Fabrication
2- Manually Hinged Underbody Auger Racks
Underbody Rod Storage
2- Rear Mounted 36" Hydraulic Leveling Jacks
2" Mast Standpipe
140 lb Safety Hammer Rack
Lockable Battery Box
Driller Platform
New Paint |
|
| B53 SOLD Pre-Owned 90 Day Warranty |
|
|
Specs
1990 Ford F 800 diesel truck
PTO powered off truck
12’ Standard body fabrication
2 manual swing out auger racks
2 double unit tool boxes
Combination auger / rod rack
2 – 36” jacks rear
24” front jack
Tilt front jack
7000lb Pullmaster main hoist
3200 lb Koening aux hoist
Safety driver hoist
Angle drill support
250 gallon water tank with under tank storage
2’ mast stand pipe
Gimbal coupling
SPT Automatic hammer
Rebuilt hydraulic valves
Resealed main hoist
Repainted drill white
To view full general specifications for a B53 click
here. |
|
B37 Geothermal SOLDNew
The Mobile B37 is designed as a small compact geothermal drill for either mud or air rotary. |
|
 |
Specs
The B37 is equipped with a ten foot stroke and 2 speed head for geothermal applications, and can be fitted with a large mud pump, a make and break system, rod racks, injection pump or oiler. The B37 will also be available with a multipurpose ten-speed head for geotech or core drilling.
To view full general specifications for a B37 click
here. |
|
B47 SOLD Pre-Owned 90 Day Warranty |
|
Specs
1990 B47 HD Refurbished with 2,425 hours
Mounted on a 1991 International 4800 4x4 diesel truck
26,000 GVWR, with 42,446 miles
The B47 HD with a 4 cylinder Deutz diesel engine
Includes the standard 5-speed rotary head
developing 5,000 ft-lb of torque and maximum of 365 rpm
6 ft feed system has 10,600 lbs of pulldown force and 14,100 lbs of retract force
Drill Options included are:
New feed frame
New 19 ft mast assembly with tool guide
2,600 lb main hoist
Safe-T-Driver hoist
Cathead
In-Out Slidebase
3L4 Water pump
250 gallon water tank
2- Tool boxes below deck
2- Combination auger/rod racks above deck
4- 36” stroke hydraulic stabilizing jacks
A universal auger coupling
All new hoses
All hydraulics tested and checked
Truck includes:
DT 360 diesel engine, 38 gal fuel tank,
Truck tires in excellent condition, 153” WB, air brakes,
Power steering, AM/FM radio, white cab
Drill painted red |
B90 SOLD Pre-Owned 90 Day Warranty
1992 Mobile B 90 Drill mounted on a 1992 Ford L 8000 3 axle diesel, 240 Hp, 10-speed
manual transmission. This rig has been serviced with all hydraulics checked,
new hoses and thorough testing. |
|
|
Specs
43,545 miles
200 Hp diesel deck drill engine
2-speed top drive rotary head
17 ft stroke
Side-to-side and in-out slidebase
12,000 lb main hoist
Mobile Safe-T-Driver hoist
2,500 lb auxiliary hoist
Jib joist and single rod loader
36 in leveling jacks
Hydraulic rod clamp and break out wrench
3L8 progressive cavity water pump |
|
| B3500 SOLD Pre-Owned 90 Day Warranty |
|
Specs
To view full general specifications
for the B3500 click
here. |
|
Back To Top
|
|
|
